About my car

The truck is a base model and has a 4.3 liter with the 4l60 transmission with 3.05 rear axle. Since I had it I tear the motor down and rebuild it. Putting a a20/20 balance crankshaft and some Ls3 pistons and rods that are nickel plated. Then upgraded the rear axle with the 3.73 gears to get a better off the line response. Also fuel economy to save a little money in the long run. Since then the truck has been rolled over from going 80 MPH back to Phoenix. Had the truck saved from going to the junkyard for life. Now it's still putting 300 rwhp and at about 396 horsepower with some companies cams and Edelbrock lifters and valves. Everything else is mostly stock. The suspension has a thick torsebar and heavy upper ball joint arms and lower control arms. The wheels and tires are 285/65/20 from a 07 Gmc Yukon. I had to trimmed the inside wheel liner to let them fit and it rides a lot smoother.

On the Job site

Photos

Axle replace

Servicing

My brothers 1976 Chevy K5 blazer

DIY Repair

Cleaning micky

Car Wash

A Monday drive

Lifestyle