Motor Swap 

Thought I had piston slap, So I bought a rebuilt 97 TJ motor, ended up that only my flexplate was cracked, but I decided to swap it anyways. This is at 205k.

Total Cost: $500

Interesting for you

All new fuel system

All new fuel system

DIY Repair
The old fuel tank and line had been jammed full of rust sludge and whatever else was left of the 10 year old gas so it's now been replaced by a 25...
Engine noise

Engine noise

DIY Repair
Drove the truck to work it ran good came out at the end of the day and now it has a popping sound. I went thru the carbs , put a new distributor...
New fog lights

New fog lights

DIY Repair
Well the old fog lights were worn and no matter what I used to clean them up they would not clean up too clear. Solution. . . new replacements....
TAILPIPE HANGERS

TAILPIPE HANGERS

DIY Repair
Had to replace tailpipe hangers as they rusted off. and wouldn't you know as this problem begins to be resolved I get a engine light, turns out to...
Inner Fender well replacement

Inner Fender well replacement

DIY Repair
Here's my inner fender project I did from over the summer. This shows each stage. Original, wire brushed, primed, undercoated.
Valve Cover gaskets replacement

Valve Cover gaskets replacement

DIY Repair
When i bought the truck i had a few things that of coarse needed too be replaced. . . The seal on the valve cover was lleaking so i went ahead n i...