Jeggs HEI distributor conversion 

Recently found out that my distributor that came with the truck fried itself after getting her to idle for 5 minutes. So I ordered a new dizzy from Jeggs and didnt realise that the original in my truck was a ESC distributor and nobody makes that part anymore. So after a day of trying to find top dead center again and re-time the motor I finally got her to run and drive.

Total Cost: $110

Interesting for you

New Advanced Induction Heads

New Advanced Induction Heads

Engine
This new addition makes this beast come alive. These heads are the highly sought after "243" casting ZO6 heads off the LS6. Sent them off to...
Rotor swap complete and installed

Rotor swap complete and installed

Engine
Got the m122 rotors installed in the m112 case, Got the drive shaft in, the rear diff cover on, and the 4# lower pulley installed, also got...
Ole Glory

Ole Glory

Engine
1977 f150 with a built 351m with a 6 inch skyjacker lift with 35inch bf Goodrich mud terrains on mickey Thompson wheels. . .
Best Modern Muscle Car

Best Modern Muscle Car

Engine
KennyG1 also takes Top award for Best Modern Muscle Car at World of Wheels in Edmonton, AB. Thanks to CCMR for their build over the last 2...
433 getting back on track

433 getting back on track

Engine
I haven't updated my engine build for a variety of reasons. I was sick for weeks this spring, then the pistons were not machined correctly and...
Mods done to the car

Mods done to the car

Engine
I have spent about $3, 000 in modifying the car and here's what I have done so far. Steeda CAI SR Performance 62mm throttle body Stage 2 Comp...