Dyno sheet

After all the supercharged work with additional upgrades the car dynoed at 777 RWHP, 893 HP, 11.1 lbs of boost, 693 ft. Lbs of torque and 10:1 compression. After installing the Corsa Extreme 3 in exhaust it added another 30 HP.

If I change my cam again to support the supercharger more, change the pulley and tune the car it will add another 125-150 HP.

Comments

Interesting for you

Chuck Ruffin in Jeep Wrangler Yuppy FIL

Weber 32/36 DGAV Carburetor Installation Continued...

Engine

After installing the Weber Carburetor, it fired right up. I installed the Air Filter, and tucked the Jeep in for the day. Went outside to start it...

Comment Like 0

Brett Patke in Chevrolet Camaro Night fury

Stripped threads

Engine

Cam retainer plate holes are stripped after another block strip down possible be driving next year if it isnt sold by than

Comment Like 0

Joshua Hornberger in Dodge Ram Aka the Dirty dodge

Upgrading the motor

Engine

The 12 valve is a very capable motor and I want to make it more powerful also the engine revs really low so I plan on making it rev higher then do...

Comment Like 15

Roger Whitaker in Chevrolet Chevy II

Starting up 1st Engine. Cam bearings went out.. Comp Cams warrantied it.

Engine

Comp cam, s sent new cam and lifter set. Used a diff cam, 2nd time around.

Comment Like 10

Jim Surratt in Chevrolet Silverado

New Set up.....

Engine

So I added a 227/231 116A Cam, and TSP CBC Heads and pulleyed down the supercharger to 8psi. Made 570 hp /600 tq at the rear wheels. So, ...

Comment 1 Like 30

Bryan Erwin in Buick Regal The silver bullet

New intake and carb

Engine

Swapped out my torker 2 manifold and Holley carb for a summit racing stage 1 high rise intake and put a summit racing street strip series750 cfm...

Comment Like 1