Head work 

Well i recently ran into a compression problem with the bmw, so here soon i will ripping the head off and rebuilding it, i will post again when i get it off and find the reason for the low compression, im thinking either collapsed lifter or bent valve, but like i said ill post again when i get her done!

Interesting for you

Other things that have been going on lately.

Other things that have been going on lately.

DIY Repair
So over the last few months I fixed the throttle problem and drove it just fine for a while until the whining transmission noise kept getting...
Welding some frame.

Welding some frame.

DIY Repair
I had a little crack in the frame kinda near the driver side engine mount, so I figured I patch that up before it got worse.
Radiator Replacement

Radiator Replacement

DIY Repair
In the cold months my Cherokee's Radiator would leak between the tank seams. So this year I decide to replace it in summer, So I went ahead and...
PerTronix Electronic Ignition, new plugs, cap and rotor, battery, cables... And a good cleaning.

PerTronix Electronic Ignition, new plugs, cap and rotor, battery, cables... And a good cleaning.

DIY Repair
Looks good, runs great!Next up, exhaust. . .
Pugot BA10/5

Pugot BA10/5

DIY Repair
Any one got any ideas on trying to fix a tranny? My BA10/5 is stuck in 4th. Is there any way I can try and get it to shift again or is it just done?
I finally started on the Clutch Project - Day 1

I finally started on the Clutch Project - Day 1

DIY Repair
I have put off the clutch for so long. I finally got some good hands on the job to help me out. Here are a couple of photos of us doing the work.