in Dodge Dakota Pebbles

Power

What happened is I spun some bearings while rescuing some stuck trucks. I was able to get the 3 trucks mobile but crippled Pebbles. We were able to get Pebbles out of the mountains the next day thanks to a snow storm and some good friends. Back at the shop I pulled the 4.7l, tranny, and t case out. Now that some medical problems have and are being dealt with, the stoked 302, "331", 4 speed manual transmission and t case are in. Waiting for a few parts to get here to finish the swap, just some wiring, can't wait.

Comments

Interesting for you

John McNally in Chevrolet Malibu

new motor time

Engine

so I detonated the motor the last race of the season now we are trying to decide what to do for a new motor should I go low comp and add blower or...

Jeremiah Mastin

Jeremiah Mastin in Oldsmobile Cutlass Supreme FLINT HOOKER

Pulled old motor out

Pulled old motor out

Engine

Doin a motor rebuild over the winter

David Garza in Chevrolet Camaro ZL1 Panda

ZL1 mods

Engine

some performance mods ive done so far. Fore double pump fuel system, e85 flex, brian tooley racing stage 3 cam, kooks long tube headers, ...

Comment 3 Like 4

Harold Grier in Chevrolet Camaro Flying turd

Engine mock-up.

Engine mock-up.

Engine

Mock-up of engine in front of my state of the art shop. Although most of the car was built before the carport.

Comment Like 17

Jerry Barnard in Ford F-Series tick a lick

Cam is now in.

Engine

Thanks to a dude I used to work with the cam bearings are now in and its time to finally rebuild.

Martin c in Chevrolet Monte Carlo DatDude

Have to change out the distributor and gas tank bad sending unit also

Have to change out the distributor and gas tank bad sending unit also

Engine

What you guys think about this MSD?There's a ticking coming from the old one. So I think it's time.

Comment Like 10