Kryptonite ball joints and traction bars. 

I decided to change my ball joints so I went with the Kryptonite brand. They have a lifetime warranty. While I was at it I added Procomp traction bars. This was a little difficult because I wanted to keep my Firestone airbags. The airbag bracket uses u-bolts and clamps around the lift block and axle. The Procomp brackets go under the lift block and on top of the axle. So I ended up fabricating the airbag brackets to work with the traction bar brackets. I did have to weld the airbag bracket to the Procomp bracket on top. The ball joints ran $180 and traction bars were $480.

Total Cost: $660

Interesting for you

First Look

First Look

Suspension
This this is the first I've seen of the Beast since checking it in to the shop to have the front suspension rebuilt completely. As well as a...
Feeling flexy

Feeling flexy

Suspension
Testing my flex at the 4th annual Top Jeep of Arkansas Competition. 35" from the ground to the bottom of the raised tire.
Maximum Motorsports coil overs, full tilt boogie IRS rear end bushing and stiffening.

Maximum Motorsports coil overs, full tilt boogie IRS rear end bushing and stiffening.

Suspension
All tuned by boost performance in lubbock tx
Suspension

Suspension

Suspension
These are the pics I have of what I've done tothe suspension.
Air ride

Air ride

Suspension
Got all the fittings and metal airline needed to get the rear done. Made some brackets to mount the new air valves. Also sealed and coated the...
No cut springs... Ugh

No cut springs... Ugh

Suspension
Online shopping for coil over springs are a hassle Lol too many imitation companies selling "cheap" parts Smh. . . Reading forums ppl really...