Clutch went bye bye 

About 3000 miles ago my factory clutch decided that It had enough after 32,000 miles of hard abuse and 6000+ rpm clutch drops. Pulled the transmission and installed a McLeod RST and lightweight steel flywheel. Manifold had to be taken off to reach the top two bellhousing bolts.

Total Cost: $1,100

Interesting for you

More work on the POS

More work on the POS

DIY Repair
Today I'll be putting on a new battery and cables hopefully that solves my charging issues I know whenever it's running the - indicates that it is...
Fixed the throttle response problem.

Fixed the throttle response problem.

DIY Repair
So a while back I was having issues with my throttle wanting to take off from me whenever I would start rolling forward. Turns out the whole...
Welding some frame.

Welding some frame.

DIY Repair
I had a little crack in the frame kinda near the driver side engine mount, so I figured I patch that up before it got worse.
Dead alternator

Dead alternator

DIY Repair
Today I had to replace my alternator. My trailer light plug in has a faulty wire somewhere that I have yet to find. I pulled a borrowed trailer...
Undercarriage clean up

Undercarriage clean up

DIY Repair
I have a solid car but the undercarriage didn’t 👀 the same. So I had cleaned it the best way I could. See what you think 🤔. First is the ugly...
Engine issues

Engine issues

DIY Repair
Trying to decide whether or not to just buy a head to replace the cracked one, or buy a low mileage complete engine. Nit sure if there's further...