Well here we go again!!!!!! 

Well got the Falcon drove it once to DMV for inspection all good but brakes soft, well next time I went to drive it they went to floor NO BRAKES damn lucky I was still in my driveway. So called buddy to take it to his shop for brakes that's were the real fun begins, brakes needs new master cylinder but while looking over car found a couple freeze plugs leaking and covered with sealant surprise another half-assed repair well you know what they say when you buy sight unseen. Guess I'll be doing repairs again and farming out some I cant do..$$$$$$$

Interesting for you

Getting closer to driving.

Getting closer to driving.

DIY Repair
I got the brakes all situated and the motor and trans in. All that's left to get it driving is to get a the engine out back together figure out...
Got her fixed!

Got her fixed!

DIY Repair
Took a while but she's turnin and burning again yeeeehoooo
Bleeding the master cylinder

Bleeding the master cylinder

DIY Repair
The truck is slowly but surely getting back together hopefully it will be moving in about a week
Pugot BA10/5

Pugot BA10/5

DIY Repair
Any one got any ideas on trying to fix a tranny? My BA10/5 is stuck in 4th. Is there any way I can try and get it to shift again or is it just done?
Welding some frame.

Welding some frame.

DIY Repair
I had a little crack in the frame kinda near the driver side engine mount, so I figured I patch that up before it got worse.
New parts getting ordered.

New parts getting ordered.

DIY Repair
Thanks to the support and votes of everyone we are now able to order new parts to get our build one step closer to being complete. Thank you...