PCV system + tune up

replaced the following:
injector o rings
oil trap
engine intake manifold gasket
breather box
breather hose and vacuum hoses
spark plugs
fuel filter
also did the torsion bar strengthening mod with a couple washers on both sides

also put 0w40 mobil 1 in for the first time instead of 5w or 10w. i am now getting 26mpg instead of 21-23

Total Cost: $260

Comments

Interesting for you

Jacob Thomas Miller in Toyota Hilux

Broke the power steering pump

DIY Repair

Turns out the power steering pump was held on by one bolt to my engine block, all it took was one little curb and it sheered right off. Now I just...

Comment Like 0

John Morin in Chevrolet Silverado Lucille

Almost fixed

DIY Repair

Got the upper control arm and the inner tie rid replaced, aligned and driving straight all that's left is the qtr panel

Comment Like 19

Garrett Horner in Ford Bronco Brutus

Welding some frame.

DIY Repair

I had a little crack in the frame kinda near the driver side engine mount, so I figured I patch that up before it got worse.

Comment 1 Like 16

Jerry Barnard in Ford F-Series tick a lick

Intake gasket time.

DIY Repair

I'm going to port my intake and I figure if I'm going through the effort of updating the intake I may as well ue the good gaskets this time.

Comment Like 0

Johnny Burbatt in Pontiac Bonneville Big Bad Wolf

Engine swap

DIY Repair

Mounts complete and pinned down. Drivetrain tuning next !

Comment Like 0

Dawn Sullivan in Ford Mustang Harley Quinn

Even a woman can work on her own car!

DIY Repair

Shocks were loose in the rear. Got underneath it MYSELF and fixed it MYSELF. No help! That's right. Even a woman can fix her own car. Hahaha

Comment 4 Like 13