My Cutty 

I bought and rebuilt a rear axle that came from 1967 Pontiac GTO. It's a 8.2" GM b.o.p. Dana rear axle with a limited slip posi trac differential with 2.76 gears. I also installed a RightStuff rear disk brake kit. I also bought a 10 bolt Oldsmobile W-27 rear axle cover. Turned out nice.

Total Cost: $600

Interesting for you

Changing 7-1/4 out

Changing 7-1/4 out

Drivetrain
Replacing 7-1/4 for 8-3/4 w/ lsd 3:91 and super stock springs and moser axles and large bolt pattern. so back to steel wheels for awhile, and I...
Custom Traction Bars.

Custom Traction Bars.

Drivetrain
Just installed my new Custom made Traction Bars. Pinned so they can be remove when hauling heavy loads.
Upgrading transmission to 6 speed manual trans behind 700+hp 427 bbc.

Upgrading transmission to 6 speed manual trans behind 700+hp 427 bbc.

Drivetrain
Bought this one of 1966 cus to built A/C Cobra , by Detroit City Customs in Florida. ( Mike & Mike) I have repainted it to a custom pearl blue...
Welded Axle Tubes

Welded Axle Tubes

Drivetrain
On first and second generation F bodies, the rear end is attached to the car by leaf springs. While this works, it allows for a lot of rear end...
Axle

Axle

Drivetrain
Finally got the funds to get the new axle gears and all new bearings and seals. I got the rear suspension out then dropped the axle. Not very fun...
Getting Ready for COTA in Austin,TX

Getting Ready for COTA in Austin,TX

Drivetrain
Watkins Glen was a wonderful Time, Now getting new bearings and brakes, ready for C. O. T. A. in Austin TX. It's The SVRA National Points...