It's Alive 

Again, it's been awhile since my last update. A hurricane and a few other life events but, the Camaro is almost done. All that's left is installing the glass and interior, touch up a couple of spots and done.

During this build, I've experienced an increasing number of bad parts. Name brand, American Made, expensive JUNK! I've been building cars for a long, long time. I've noticed a decline in quality and customer service from these companies,

over the last 7 years. Holley, Hooker, MSD, ACCEL and many others are all owned by the same people. I've tried to stick with SEMA endorsed products but, no more. SEMA does nothing for the consumer and that makes it really hard for the home-built Hot Rod crowd.

Anyway, here are a few shots and a video of the first start up. I installed the FiTech - EFI Go 4 - 600 HP system on the car......twice. The first one had a bad ECU, right out of the box. Still, it sounds great.

Interesting for you

Driveshaft is out

Driveshaft is out

Restomod
Finally got the driveshaft out today. All the bolts came out easy except one, but I was able to eventually get it out.
1962 unibody conversion

1962 unibody conversion

Restomod
My attempt at making a restomod/rat rod/daily. It's been 2 years in the making but it's a lot of fun making something that is custom to mytaste. ...
The engine for Rita

The engine for Rita

Restomod
Here's the engine that I'm building for my Rita. Its a 307 chevy from a '68 Chevelle, and I also purchased the Powerglide transmission to bolt...
Finally fixed my Dakota Digital speedo issue

Finally fixed my Dakota Digital speedo issue

Restomod
Ok, if any of you plan to use a Dakota Digital dash upgrade you should check this out. The problem was that after driving a few minutes and...
1950 Chevy 6400

1950 Chevy 6400

Restomod
HHey editors, I JUST did this on the last page.
95 Ford F-250 overhaul

95 Ford F-250 overhaul

Restomod
I've got a 95 Ford F-250 that has motor and trans issues, doing a total overhaul on it, and customizations