Random misfired..etc 

So I bit ago I got a few codes showing lean on both banks, random misfires and a series of other codes. We've gone thru slowly knocking out possibilities and just replacing things that could have something to do with it that needed to be replaced around this point in its life anyways. So far we have replaced: fuel filter, fuel pressure regulator, fuel pump, mass air flow sensor, crank relearn, put back to original stock SS tune, tune up on tech 2 scanner, spark plugs and wires had been replaced already been replaced by me about 6 months previous. We have made huge strides in improvements on how it runs and in performance throughout this process but the only remaining fault is that it goes into too low of idle when put in gear or letting off throttle causing it to die occasionally. Thinking it's possibly a vacuum leak somewhere so looking into that at the moment.

Total Cost: $400

Interesting for you

New mid shift bearing

New mid shift bearing

DIY Repair
My mid shift bearing started a vibration it is the original from 230, 000 miles. So I replaced it what a pain in the ass.
Parts

Parts

DIY Repair
Got to get her right✌new parts
Ignition Coil and Starter

Ignition Coil and Starter

DIY Repair
MMy truck decided too go dead on the road when i stopped, so i pushed it myself cause noone in the state of Va was nice enough too help soo i did...
New egr valve and egr position sensor  replacement

New egr valve and egr position sensor replacement

DIY Repair
The old one was wore out bad and was packed with carbon deposits
Cab

Cab

DIY Repair
Worked hard the last two days and got the cab set and bolted down we now have the full cab done except the radio and the switches for the ac...
Wheel trouble

Wheel trouble

DIY Repair
I was a little busy with work and decided to have a Mavis in virginia rotate and balance my tires just because I'm lazy and they decided to not...