Current build 

Going for a full 383 stroker build, big cam, big heads etc. Also going to lower it so it sits a lot better. Bring on the power!

Total Cost: $5,000

Interesting for you

bottom end and heads put in new block

bottom end and heads put in new block

Engine
refurbished crank, cam specific to low and midrange torque, aluminum heads, new pistons, rods, and caps.
Rebuilt the 283 !  13:1 & bearings, Rings & Iron Heads.....

Rebuilt the 283 ! 13:1 & bearings, Rings & Iron Heads.....

Engine
The LONG TUBE HEADERS added a whopping 78 Ft-Lbs. of TQ at 4000 rpm !!!!!! Over the shorties ! I don't use Long tubes, but I shall !!!It also...
Catastrophic Engine Fail

Catastrophic Engine Fail

Engine
When we push the HP to over double the stock, we should make sure the bottom end is kept ahead to handle. One connecting rod failed and...
Drive train in!!

Drive train in!!

Engine
Finally got around to putting the motor and transmission back in. Found out that the transmission is a FMX. I have plans on trying to test start...
World of Wheels

World of Wheels

Engine
Complete Exterior Cut & PolishAs we prepare for the Edmonton World of Wheels (Mar 3-5) have just completed professional Cut & Polish including...
Ysi 3.1 pulley

Ysi 3.1 pulley

Engine
Ysi direct drive on 3. 1 pulley billet impeller 17lbs of boost