433 Ready to Roll 

I did my tilt test and the new BOP 1 piece main seal seems to be leak free. I installed some of the rest of the accessories and will be off to my machinist's tomorrow to run this engine in for the first time on his test stand. After run in, we will cut open the oil filter and examine the drained oil for any bearing particles. It takes me two days to get this engine in or out of this car so it is well worth it to run the engine in on a test stand to make sure everything is right.

Interesting for you

Engine overhaul

Engine overhaul

Engine
So. . I recently posted my jeep an the conversion I've been elbow deep in since Christmas. Well. . . Had a minor setback. . upon discovering...
Engine maintenance, Cleaning, and Detailing

Engine maintenance, Cleaning, and Detailing

Engine
On April 14th 17, my wife and I did some work on the Mustang getting it ready for car show season and our Carlisle PA. trip. First thing we did...
Why I put a 327 in my vette

Why I put a 327 in my vette

Engine
Well I decided to put a 327 small block with 400 horsepower in my Corvette because first of all the generation my Corvette was made in the old...
DYNO Pull 2

DYNO Pull 2

Engine
September 2016 Next run with updated tune at MJD Performance.
Out with the old

Out with the old

Engine
So a opportunity came up and I had to jump on it. I traded my B18a engine for a QSD h2b setup. Engine is out, prepping the h series to go in. ...
Engine

Engine

Engine
Finally had time to get the engine pulled apart. A lot more damage to the piston heads then first thought. Pistons 6 and 3 both have corrosion...