Springs 

So as you can see in earlier pictures the back of my car had been sagging for years. The springs finally gave up showing off for some local kids. I had bought used springs but from sitting in the wrong place they were junk. So i put together springs from leftovers from other projects. I also added adjustable shackles in case i needed more room . End result the car sits level on the lowest hole in the shackles ,with the new shocks it drives a ton better . Now on to other parts..

Interesting for you

New parts

New parts

DIY Repair
I just put a new holley 720 cfm double pumper carb and a edelbrock torker intake manifold
ok time for rewiring and rebuilding

ok time for rewiring and rebuilding

DIY Repair
when I got Sarge I knew it was going to need a few things, but when you go into changing out tail lights and find 3 spliced areas in about 3 feet...
Upper control arm Mount

Upper control arm Mount

DIY Repair
Installed a new Mount for the upper control arm. Finally NO wheel hop.
Ignition Coil and Starter

Ignition Coil and Starter

DIY Repair
MMy truck decided too go dead on the road when i stopped, so i pushed it myself cause noone in the state of Va was nice enough too help soo i did...
New egr valve and egr position sensor  replacement

New egr valve and egr position sensor replacement

DIY Repair
The old one was wore out bad and was packed with carbon deposits
SVE hood strut kit

SVE hood strut kit

DIY Repair
New SVE hood strut kit from LMR.