motor tear down, pull out, rebuild and put back in 

ttearing motor down to install the new upper and lower assemblies, should be around 2400HP when its complete. Ill rip the motor out tomorrow

Interesting for you

Installed new fuel pump/float

Installed new fuel pump/float

DIY Repair
I installed a new fuel pump with a float (in gas tank), cause my gas needle wasn't working properly, even after I installed a new anti-slosh...
Mustang

Mustang

DIY Repair
Gotta love doing carb work
Hot and cold

Hot and cold

DIY Repair
Been a very hot and cold build so far. Truck is from 99 so as well as adding to it, just about every part has been replaced. From a front end...
Engine issues and body work

Engine issues and body work

DIY Repair
So I got my engine in and all put together and it has almost no oil pressure and still has a knock somewhere. So I am going to take it out and...
Phase 1: The Fuel System - Fuel Tank Repair

Phase 1: The Fuel System - Fuel Tank Repair

DIY Repair
It's been about two months since I have taken on the fuel system repair. When I got the Jeep, I found the fuel tank punctured. Looks like someone...
The guts - V1 Install Pt2

The guts - V1 Install Pt2

DIY Repair
I did a lot of research about ways to hide my V1. There were people putting them in headrests (mine are too small or have screens in them) and in...