Car of the Day
Ford Mustang Christine RMR 1262
Mustang (4th Gen)
Rod bearings 3&7 bad. New crank in the works and then it's on.
Why are you reporting this post?
Contains Hate Speech
Select one reason.
Share with friends
Load more comments
Interesting for you
Pontiac Bonneville Big Bad Wolf
Old to new
Had to hack off the old engine mounts and start all over. Doing a retro fit and lining up the engine and drivetrain to figure out engine mount...
Ford Thunderbird Grey Ghost
Shaved doors and trunk and all badges
Finding a place to put actuator . . . to run wires where needed. . . Installed in door. . and run emergency opener cable. , Running all wires for...
Hyundai Veloster Turbo Lady
Getting better at customizing decals
Started paying outrageous money for car stripes and decals to local businesses. I was hurting my own pockets and decided to play around with...
Cadillac Coupe De Ville
New lock up
I decided to get rid of my 14 inch cylinders and install 30 inches and fabricate my trailing arms and chain Bridge
Chevrolet Bel Air
The rearend !!
The rearend is a winters rear with wide 5 hubs, it has a aluminum spool with 4:86 ring and pinion, disk brakes with wildwood 4 piston calipers,...
Chevrolet Camaro Ghetto-Ride
Steering Brace (Wonderbar) Installed
Installed the 'WonderBar' today pretty much everyone else installs on these vehicles. Apparently the purpose of these performs two functions. ...