All on mod pic tutorial 

Ok, so last year I converted my entire truck over to LED. I am using 80w led headlamps for both high and low beam. In order to get an increase in lighting the "All on mod" needs to be done. Here is what I did. Using a 12v min 1A diode available from just about any radio shack or electronics store I soldered a short lead of wire to each end and covered the exposed wire with heat shrink. Next you locate the high and low beam relays in the power distribution block under the hood. Once you have located these using the chart inside the cover, identify the hot post (#85) on each relay. Remove the 2 relays and install the diode between these 2 sockets in the block making sure the marking ring is towards the high beam relay. Insert the wires into the socket and reinstall the relays. This allows current to flow from the high beam circuit to the low beam circuit at the same time turning on all 4 headlights. If done correctly there is no risk of short or malfunction since you are using all the factory wiring and fuses.

Total Cost: $3

Interesting for you

New headlights

New headlights

Headlights
Got a new set of rgb headlights today. Not sure how I feel about them yet. They are brighter than my old LED headlights though. The white halo has...
Eyes

Eyes

Headlights
More pics of the new lights
Retrofit headlights

Retrofit headlights

Headlights
Well I'm am finally on the last phase of building my headlights. The outcome is better then I expected quad projectors installed and then rgb...
Before & after new HID headlights

Before & after new HID headlights

Headlights
New HID headlights LED blue headlights
New eyes

New eyes

Headlights
Davine is getting eye surgery. The mounts that hold the headlights in place are too small for the headlights I bought so I'm getting them trimmed.
Headlights

Headlights

Headlights
So I'm looking into getting new headlights. And was interested in what other people had to say. I like the look of these better. https://www....