Thank you Milford Brake and Tire... 

A couple of weeks ago, while taking Angelica on a drive, I drove over a piece of log that I thought would clear underneath. I was wrong- a loud bang and all of a sudden there was a new ratting sound.

I thought it was exhaust hangars and isolators that may be the issue - getting underneath is hard do to the mustang being so low (less than 5 inches clearance). I even had a good friend send me exhaust hangars from their GT500 to do a swap.

Milford Tire and Brake was nice enough to "gently" get my car up in the air and we inspected the entire undercarriage to see what could be the source of the rattle. While the exhaust needs to be realigned after the hit (it's slightly off center) we discovered the rattle was due to a loose bolt on the top of the front sway bar. A quick tightening and she's quiet as a mouse again.... not only did they help me - they did not event charge me for the time. We did go for an extended test drive - I guess that was considered payment enough.

These guys rock...

Total Cost: $0

Interesting for you

Getting some things in

Getting some things in

Exhaust
Got a lot about to go on the Colorado. Ottp headers will be here Wednesday and the other muffler and trans cooler will be here fridayCan't wait...
New Hedman headers and fuel pump complete the performance package

New Hedman headers and fuel pump complete the performance package

Exhaust
I have not posted in awhile. . . been in the middle of selling my home and moving from one state to another. Since my home had a lot of strangers...
Exhaust Highest Decibels competition

Exhaust Highest Decibels competition

Exhaust
Highest Decibels competition. I won with 125. 4 decibels.
Loud or louder...

Loud or louder...

Exhaust
What do my mustang people think or a o/r LTH with a full 3" over axle pipe no resonator and roush axle backs ? To loud or should I go high flow cats ?
Headers

Headers

Exhaust
IInstalled some headers a month ago.
Cage is solid

Cage is solid

Exhaust
SSpent 450$ on square stock and around 4 days fabricating and welding it