Fuel Pump & Fuel Filter 

I was able to do some wrenching on the old girl over Fathers Day week. My dad was In town and we worked on it together. Objective was to get it running. So we started with bleeding the clutch Master Cylinder. Then we wanted to see if it would start. So we cranked her over and we knew it wasn't getting fuel because we could dump some through the carb and it would run a few seconds. First time in 13 years she has had fuel running through her body!

So we found the fuel pump had failed over time, then the fuel filter was dried up. Of course our fuel lines were so dry rotted we took those off and replaced them too!

So I'm currently with the Fuel Tank out with new parts for fuel pump and fuel filter installed. Hopefully make some more progress on it this weekend. Stay tuned!!

Interesting for you

Welding some frame.

Welding some frame.

DIY Repair
I had a little crack in the frame kinda near the driver side engine mount, so I figured I patch that up before it got worse.
On the road again

On the road again

DIY Repair
Well after 25 years of not running she is finally ready again . Just need to get license plates and insurance and we are ready to roll. The...
Found some parts.

Found some parts.

DIY Repair
Also got some motor mounts
U  joint

U joint

DIY Repair
I broke my u joint the other day. Easy fix already had a yoke and the u-joint wasn't to pricey. Once I got all the parts probably took about a...
Time for the Upgrade !!!

Time for the Upgrade !!!

DIY Repair
I have everything ready for the drive train swap. I got all the adapters and parts to put in the Ford 5. 0 Fuel Injected engine with the T-18 4...
Gasket time

Gasket time

DIY Repair
Well its time to replace the intake gasket. I hate doing gaskets on these engine so Ii got the high end gaskets this go around.