Rear Axle 

Started work on the rear end today. I was trying to replace the bearings but i cant get them out. I'm gonna remove the spider gears tomorrow and run a pipe through to try and knock them out. If anybody has any suggestions on an easier way to get them out let me know. Once I get them taken care of I'm running new brake line and replacing the thermostat. Hopefully I'll have all that done this week.

Total Cost: $135

Interesting for you

68 318 is in

68 318 is in

Drivetrain
Took awhile but it's in, 11 to 1 compression around 400hp put a 4:10 rear axle in with 295/50r15 tires
Drivetrain additions

Drivetrain additions

Drivetrain
Added carbon fiber driveshaft by dss, ford racing axles and some supporting mods to stop the hop. Almost ready. Next is a trip to VMP for a...
Axle

Axle

Drivetrain
Finally got the funds to get the new axle gears and all new bearings and seals. I got the rear suspension out then dropped the axle. Not very fun...
Project frankenstein

Project frankenstein

Drivetrain
Cummins swapNv4500Np205new axles swapTook out the 04 axles and put in 08 axlesGoing from leads to coilsInstagram:@sinister_crewcab
Finally head to the Shop

Finally head to the Shop

Drivetrain
Doc Ray has been transported to the shop! Picked up today. This is going to be good. . . . . . .
Differential Cover

Differential Cover

Drivetrain
Replaced the rear differential cover because it was leaking but it started up again so I'm gonna have to buy some silicone. Didnt take too many...