Cab 

Worked hard the last two days and got the cab set and bolted down we now have the full cab done except the radio and the switches for the ac control. We plan on bolting on the fenders and hold and finish wiring the motor and try to get her started. Once I get the money we are going to build a flatbed and paint the truck in rino liner. Then I'll worry about wheels and tires.

Interesting for you

Driveshaft Replacement

Driveshaft Replacement

DIY Repair
So the adventure began when I dropped my Jeep off at a friends place for storage before I left for Officer Training School in 2016. Upon return, I...
New egr valve and egr position sensor  replacement

New egr valve and egr position sensor replacement

DIY Repair
The old one was wore out bad and was packed with carbon deposits
The Switching Center - V1 Install Pt 1

The Switching Center - V1 Install Pt 1

DIY Repair
Soooo. . . I was fooling around in the garage one Saturday afternoon bored as hell. I'd just cleaned the garage and I started thinking about my...
Breaking hub units

Breaking hub units

DIY Repair
There's a problem with running the these big tires and rims with this off set. Looks good but the factory hub units can't take much punishment. ...
Dead alternator

Dead alternator

DIY Repair
Today I had to replace my alternator. My trailer light plug in has a faulty wire somewhere that I have yet to find. I pulled a borrowed trailer...
photos of the work on the 88 TA

photos of the work on the 88 TA

DIY Repair
https://www. facebook. com/1988ta/