And the front end is all apart! 

Rear end apart soon, then clean all the parts, then back together.
No surprises so far other than a crunchy rear wheel bearing, so we'll replace both. Fronts getting new due to the new uprights (Evo).

For clarity, the parts are:
KW Clubsports with custom spring rates
Brembo GT brake kit, 6 piston front mono block caliper and 2 piece rotor, aluminum hat
ERP shock top plates
ERP monoball bearings
RS Sway bar
Tarett drop links
ERP front tie rod ends with bump steer
Inside will be 993 factory that are welded to eliminate the rubber (not shown)
993 Evo uprights, lower monoball, abs sensor, etc
Rothsport steering rack bushings
Rothsport strut bar (not shown)
Rothsport steering rack brace (not shown)
New bearings (not shown)
Stainless brake lines (not shown)
And a few other bits....

Interesting for you

Axle

Axle

Drivetrain
Finally got the funds to get the new axle gears and all new bearings and seals. I got the rear suspension out then dropped the axle. Not very fun...
New axel work

New axel work

Drivetrain
My truck originally had 355 gears. When I had the stock 351 M motor with 200 HP pushing 40 inch tires I decided to go with 456 gears. They were...
Drive train swap

Drive train swap

Drivetrain
Last winter I took on the task of swapping the drivetrain from the transmission back. I swapped it with the drive train from a 1990 ram charger...
Up dat

Up dat

Drivetrain
So far I did black wheels and red calipers it's chip and a k&N air filter I only put the best oil in her . . . . . . i will have more picture latter
Custom Traction Bars.

Custom Traction Bars.

Drivetrain
Just installed my new Custom made Traction Bars. Pinned so they can be remove when hauling heavy loads.
Mods!!

Mods!!

Drivetrain
Been working on meangreen and getting it ready for the front ARB, rear ford 8. 8, 4. 56 gears, and sye.